# DC Power Switch Manual
# Overview
This section introduces the DC Power Switch — a remote-controlled power cable for integrating USB-powered devices into camera trap setups.
# Overview
The Camtraptions DC Power Switch is a cable with an integrated controller that allows power to be turned on and off via a standard camera remote.
The cable has been designed to work seamlessly with Camtraptions sensors, wireless triggers and a wide range of other camera accessories. Among other applications, this enables various USB-powered devices (for example an LED video light) to be incorporated into remote control or camera trap set-up.
#### **Connector**
The DC Power Switch has a **2.5mm jack** that is designed to plug in to Camtraptions equipment or any remote release with a Canon E3-type female socket.
#### **Power Input**
The DC Power Switch has a female DC power input socket. This socket accepts a wide input voltage of **6V to 15V**.
#### **Power Output**
The DC Power Switch has a male DC power output socket. This socket is simply connected to the input power source when the switch is activated. Therefore, the voltage of the power source should be matched to the voltage requirement of the device that is being turned on.
#### **Power Rating**
The switch has a maximum power rating of **35 Watts** (i.e. it could be used to supply up to **5 Amps at 7V** or up to **2.8 Amps at 12V**). If more power is required then two switches could be used in parallel.
#### **Operating Modes**
The switch has three operating modes, **1**, **2** and **H**, which can be set using the slider.
# Operating Modes
This section explains the three operating modes — Mode 1, Mode 2 and Mode H — and their compatibility with different sensor configurations.
# Mode 1
When a press signal is detected, the switch turns **ON** for **15 seconds** then automatically turns **OFF** again.
The ON time is extended by a further **15 seconds** every time an additional press is detected.
#### **Compatibility**
For use with the Camtraptions Wireless PIR Sensor v3 (purchased after 18th January 2021), using video programs **1**, **2** or **3**.
# Mode 2
First press turns the switch **ON**, second press turns the switch **OFF**.
#### **Compatibility**
For use with:
- Camtraptions Wireless PIR Sensor v3 (purchased at any time), using video programs **4**, **5** or **6**.
- Camtraptions PIR Sensor v2 programs **14**, **16**, **18**, **20**, **22**, **24**.
# Mode H
The switch is **ON** while the press signal is held.