Operating Modes
This section describes Mode A and Mode B — two different recording behaviours that can be selected using the slider switch on the cable.

Mode A
Camera is woken, records for 15 seconds then automatically returns to the powered-down state. Recording time is extended by a further 15 seconds if there are additional full-press signals during the recording period. 

 How It Works 

 The input from full-press starts the camera recording. Recording stops when 15 seconds has elapsed since the last full-press occurred. 

 Multi-Sensor Camera Traps 

 Mode A can be used in a multi-sensor camera trap, where multiple Wireless PIR Sensors can be linked to a single camera to cover different approach paths. 

 Compatibility 

 For use with: 

 
 Camtraptions Wireless PIR Sensor v3 (purchased after 18th January 2021), using video programs 1 , 2 or 3

Mode B
Full-press starts recording, second full-press stops recording. 

 How It Works 

 The moment full-press is detected the camera is instructed to record. Recording stops only after full-press is released and a second full-press is detected. 

 Note: This mode does not auto-power-off the camera after recording. Configure the camera itself to auto-power-off via its menu. 

 Compatibility 

 For use with: 

 
 Camtraptions Wireless PIR Sensor v3 (purchased at any time), using video programs 4 , 5 or 6 
 Camtraptions PIR Sensor v2 programs 14 , 16 , 18 , 20 , 22 , 24 
 When manually triggering recordings using a wired or wireless shutter release