Sony Video Cable v2 Manual

Overview
This section introduces the Sony Video Cable v2 — enabling remote video recording with Sony cameras via Camtraptions sensors and triggers.

Overview
The Camtraptions Sony Video Cable v2 is a cable with an integrated controller that allows remote video recording with Sony cameras featuring the Multi -type connector. 

 The cable has been designed to work seamlessly with Camtraptions sensors and wireless triggers to enable remote video recording with Sony Interchangeable Lens Cameras. 

 Functions 

 The cable can perform the following functions: 

 

 Wake the camera from sleep 

 Start and stop video recording 

 

 Connector 

 The Sony Video Cable v2 ends in a 2.5mm jack that is designed to plug in to Camtraptions equipment or any remote shutter release featuring a Canon E3-type female socket. 

 How It Works 

 The cable can receive half-press and full-press signals, which the integrated controller translates into commands to start or stop video recordings. 

 To obtain the fastest possible response times from the camera, the Sony Video Cable v2 starts a recording as soon as it detects that the camera has woken up from sleep. 

 The cable will also begin a recording if the camera is woken from sleep via any other button presses on the camera itself (for example, the menu button or image playback button). To avoid these unwanted recordings, it is recommended to simply unplug the cable until it is ready to be used again. 

 Operating Modes 

 The cable has two Modes, A and B , which can be set using the slider switch on the cable itself.

Operating Modes
This section describes Mode A and Mode B — two different recording behaviours that can be selected using the slider switch on the cable.

Mode A
Camera is woken, records for 15 seconds then automatically returns to the powered-down state. Recording time is extended by a further 15 seconds if there are additional full-press signals during the recording period. 

 How It Works 

 The input from full-press starts the camera recording. Recording stops when 15 seconds has elapsed since the last full-press occurred. 

 Multi-Sensor Camera Traps 

 Mode A can be used in a multi-sensor camera trap, where multiple Wireless PIR Sensors can be linked to a single camera to cover different approach paths. 

 Compatibility 

 For use with: 

 
 Camtraptions Wireless PIR Sensor v3 (purchased after 18th January 2021), using video programs 1 , 2 or 3

Mode B
Full-press starts recording, second full-press stops recording. 

 How It Works 

 The moment full-press is detected the camera is instructed to record. Recording stops only after full-press is released and a second full-press is detected. 

 Note: This mode does not auto-power-off the camera after recording. Configure the camera itself to auto-power-off via its menu. 

 Compatibility 

 For use with: 

 
 Camtraptions Wireless PIR Sensor v3 (purchased at any time), using video programs 4 , 5 or 6 
 Camtraptions PIR Sensor v2 programs 14 , 16 , 18 , 20 , 22 , 24 
 When manually triggering recordings using a wired or wireless shutter release