# Operating Modes

This section explains the three operating modes — Mode 1, Mode 2 and Mode H — along with the built-in overheat protection feature.

# Mode 1

When a press signal is detected, the switch turns <span class="s1">**ON**</span> for **15 seconds** then automatically turns <span class="s1">**OFF**</span> again.

The ON time is extended by a further **15 seconds** every time an additional press is detected.

#### **Compatibility**

For use with the Camtraptions Wireless PIR Sensor v3 (purchased after 18th January 2021), using video programs <span class="s1">**1**</span>, <span class="s1">**2**</span> or <span class="s1">**3**</span>.

# Mode 2

First press turns the switch <span class="s1">**ON**</span>, second press turns the switch <span class="s1">**OFF**</span>.

#### **Compatibility**

For use with:

- Camtraptions Wireless PIR Sensor v3 (purchased at any time), using video programs <span class="s1">**4**</span>, <span class="s1">**5**</span> or <span class="s1">**6**</span>.
- Camtraptions PIR Sensor v2 programs <span class="s1">**14**</span>, <span class="s1">**16**</span>, <span class="s1">**18**</span>, <span class="s1">**20**</span>, <span class="s1">**22**</span>, <span class="s1">**24**</span>.

# Mode H

The switch is <span class="s1">**ON**</span> while the press signal is held.

# Overheat Protection

The switch has an inbuilt cut-out feature that automatically turns it off if it starts to overheat. This ensures that the switch itself does not get damaged.

In practice, the switch can support devices drawing up to around **1.5 Amps** for a prolonged period of time without overheating.

<p class="callout info">If a device draws more current than **1.5 Amps**, it may be necessary to use two USB Switches in parallel.</p>