Gap Time

The Gap Time

Wakesetting Time

controls

Setthe Time

delay

Timebetween Mode

triggers,

Setdefining Onhow Time

long

Setthe Off Time

Periodic Wake Signal (note that this onlysensor will sendwait duringbefore ONit can activate again after completing a sequence. This lets you control how often the sensor triggers, conserving battery power and storage while allowing flashes to recharge and reducing the chance of disturbing subjects.

Adjusting the Gap Time

1. From the Home Screen, press the Right Arrow until you reach the Gap Time screen.
2. Use the Up or Down buttons to set the desired delay (in seconds).
3. Press the Set button to save your selection.

The chosen value determines how long the sensor will remain inactive after completing a sequence before it can trigger again.

• A short gap time allows the sensor to retrigger quickly and capture multiple events close together.
• A longer gap time limits the number of triggers, reducing the total number of images or videos recorded over time.

Practical Uses

Adjusting the Gap Time can help you:

• Reduce excessive triggering in areas with frequent animal movement.
• Conserve battery power and memory card space for longer unattended deployments.
• Allow flashes time windows)to
  recharge between triggers, especially when using multiple flashes or high power levels.
• Avoid disturbing animals with rapid, repeated flashes.

In most cases, a moderate delay provides the best balance between responsiveness and conservation of resources. For fast-moving subjects or short-term deployments, a shorter delay may be preferable, while for long-term camera traps, a longer delay could help extend system endurance.